Site - View range (you can learn about this)

Terrain tab - terrain surface - placement point (elevation, absolute elevation) - properties (material - site grass) specify the material of the current site

Insert tab - Import cad file (terrain elevation) - Set units to meters Place in F1 (sea level) Orient to view Keep all

Massing and Site - Created by Import - Import Instance - Click on the imported file in the view - Preserve Primary Contours Secondary Contours Land Lines

Simplify the surface through the tool panel to adjust the accuracy and adjust the density of elevation points (elevation points must have elevation values)

dwg file imported before vv visibility turned off

Set the density of the contour lines: Site modeling panel - Site settings (a small triangle symbol in the email) (make relevant settings)

Draw contours: Site view - Mark contours - Properties (units are set to meters, base plane, items and others)

Default 3D view - Created by import - Specify point file - The unit of the imported file is meters (the file is elevation information separated by commas)

F1 View (Sea Level) - Massing and Site - Site Modeling - Building Floor - Property Editing (Thickness, Elevation F1 (Sea Level), Offset) - Offset is 0, extends into the wall ——Draw a closed figure

Hard paving/pools/hard structures in the site can be added and created using this logical method.

Site view - massing and site - subareas - drawing to form closed road graphics

After drawing the subarea, select the material browser in the properties panel and set the material to asphalt concrete pavement road.

Note that the original sub-area cannot exceed the original site

After the road drawing is completed, in order to improve the accuracy of the road elevation points, the floor-modify sub-elements method is generally used to adjust the elevation point accuracy.

Site view - Mass and site - Modify site - Building red line - Create by drawing - Select straight line (chain, offset 0, uncheck radius, pick building red line) - Click Finish to complete the building red line Drawing - Select this building red line to see the area of ​​the current area in the property panel. During the creation phase, select the existing

Volume site (modify site) - Flat area - Create a new terrain surface based only on the same boundary points - Click on the terrain surface (drawn as elevation points) -

Detailed table - terrain detailed table - you can see the relevant area reference numbers

Hard paving/pools/hard structures in the site can all be drawn using this logical method.

Add components such as characters and trees. These components depend on the loaded related families.

Outdoor floor - Insert - Load family - Site component (volume site) - Determine the type selector to place and adjust the basketball court (attribute) neatly

Outdoor floor - use the wall tool to create a flower bed (retaining wall) - site components - select juniper (type) attribute settings (select rendering appearance) - render appearance attribute editing - check to form refraction under glass