There are two obvious differences in the installation of seismic brackets and electromechanical pipeline load-bearing brackets:

It is not good to install the anti-seismic brackets too late, as it will delay the construction period of the entire project. Some even fail to pass the acceptance test because the anti-seismic brackets are not installed according to specifications, causing the entire project to be delayed.

Therefore, it is particularly important to control the installation time node of the anti-seismic bracket.

In some fine decoration projects, the electromechanical pipelines are installed on the hoisting. Once the anti-seismic bracket is installed later than the ceiling keel, the construction will be extremely difficult, and irregular construction will also cause safety hazards.

Generally speaking, it is best if the seismic supports are installed close to the completion of the electrical duct work. As some projects have tight construction schedules, the installation of seismic brackets can be carried out according to buildings and floors. That is, the seismic brackets are installed immediately after the completion of each floor of electromechanical pipes. In this way, when the entire electromechanical project is completed, the seismic bracket project has also entered the final stage, ensuring that the entire The duration of the project.

water pipe

HVAC

bridge

On-site photos