Explanation: According to the order requirements, mix raw materials of different sizes evenly in proportion.

Check whether the raw material length is correct according to order requirements

During the mixing process, the roots and ends of the hair should not be upside down.

When mixing hair, the hair roots of each length of raw material should be aligned as much as possible

Hair of all lengths should be mixed evenly without noticeable differences

In addition to soaking hair, the messy hair produced during the mixing process is not allowed to be mixed in again.

Explanation: Sewing the mixed raw materials into pieces for the next step of bleaching and dyeing

The width, thickness and number of sutures should be determined with bleaching and dyeing.

Check the order information and confirm that the label is accurate and consistent with the product, and there should be no usage errors.

During the batching process, care should be taken not to turn the raw materials upside down.

The thickness and width of the running film should be as uniform as possible, and the stitches should be appropriately tight, not too loose or too tight.

During the film running process, you should be careful not to have the bottom line broken or missing. After replacing the bottom line, you should restart the film running from the previous one.

In addition to soaking hair, stray hair generated during the filming process is not allowed to be mixed in

After the film run is completed, separate the product into pieces. During the cutting process, cut from the middle of the connecting line.

Eat sour food

neutralize

catalytic

dyeing

Shampoo

drying

Explanation: Separate the dried hair pieces, straighten them and mix them evenly

When disassembling, the generation of tangled hair should be minimized.

During the removal process, pay attention to the fact that the roots and ends of the hair cannot be turned upside down.

When kneading, pay attention to mixing evenly and there will be no obvious difference.

Except for soaking hair, the messy hair produced during the process of disassembling and skewering is not allowed to be put into the product again.

Pay attention to safety during disassembly and be careful not to get hurt

Explanation: Select the variegated hair in the product to ensure product quality and consistency with the color card.

Hair with glue and contrasting colors should be picked cleanly

Strictly require quality, and try to pick out as many colors as possible. In addition, the quality requirements issued by workers must be clear.

Explanation: Process the variegated products so that the hair roots are on the same plane

Unruly hair produced during the hair pulling and patting process cannot be put back into the product.

Check that the middle and outer hair of each bunch are on the same plane

Explanation: Divide the hair bundles into small bundles according to the weight required by the order and then send them out for processing.

During the parting process, be careful not to turn the roots and ends of your hair upside down.

Check whether the weight of each handful meets the order requirements

During the parting process, the hair roots should be kept on the same plane. If there are different lengths, they should be patted evenly.